Vulcan-Hart EV12 Series, Руководство по обслуживанию

Страница: 14 / 33

When installing, do not bend and kink
capillary tube or damage to the control may occur.
NOTE: Install the insulating sheath around
replacement thermostat capillary tube. Route capillary
tube so it does not contact any electrical components
and secure to frame using wire ties.
10. Perform HOT TOP THERMOSTAT
CALIBRATION or GRIDDLE THERMOSTAT
CALIBRATION.
11. Check range for proper operation.
3 HEAT SWITCH / INFINITE SWITCH
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Pull off switch knob.
2. Remove washer nut from switch being replaced.
Fig. 29
3. Open FRONT CONTROL PANEL to access the
switch for a French Plate.
Fig. 30
NOTE: Infinite switches are shown.
4. If replacing switch for the top oven element,
remove OVEN CONTROL PANEL.
5. Remove wire connections from switch being
replaced. Note wire locations.
6. Remove switch from control panel.
7. Reverse procedure to install.
8. Check range for proper operation.
INDICATOR LIGHTS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Lower the FRONT CONTROL PANEL to access
the indicator lights for griddles and Hot Tops.
Remove the OVEN CONTROL PANEL for
ovens.
2. Note wire locations then disconnect:
A. Front control panel indicator lights (1, Fig.
31) electrical connections (2, Fig. 31).
B. Oven control panel indicator lights (1, Fig.
32) electrical connections (2, Fig. 32).
EV Series Electric Ranges - REMOVAL AND REPLACEMENT OF PARTS
F45586 (0716) Page 14 of 33