VTech VS112-2, Руководство пользователя

Страница: 72 / 84

72
Turn on or off the message alert tone
When the message alert tone is set
to
On , and there is at least one new
message, the telephone base beeps
every 10 seconds. The tone stops when
all new messages have been reviewed.
By default, the message alert tone is
Off .
1. Press MENU/SELECT in idle mode.
2. Press p / q to highlight Answering
sys , then press MENU/SELECT .
3. Press p / q to highlight Ans sys setup ,
then press MENU/SELECT .
4. Press
p
/
q
to highlight
Msg alert
tone , then press MENU/SELECT .
5. Press
p
/
q
to choose
On
or
Off
, then
press MENU/SELECT .
NOTE
• The message alert tone beeps only if
all the following conditions are met.
• Answering system is on.
• Message alert tone setting is on.
• There are new messages.
Area code settings
Set home area code
If you dial seven digits to make a local call
(no area code required), enter your area
code into the telephone as the home
area code. When you receive a call from
within your home area code, the caller
ID log only displays the seven digits of
the telephone number.
This feature makes it easy for you to place
a call from the caller ID log. If you dial 10
digits to make a local phone call, do not
use this home area code feature.
If you do, you cannot place local calls
from your caller ID log, as they will have
only seven digits.
To set the home area code:
1. Press
MENU/SELECT
in idle mode.
2. Press
p
/
q
to highlight Settings , then
press MENU/SELECT .
3. Press p / q to highlight Home area
code , then press MENU/SELECT .
4. Use the dialing keys to enter a three-
digit home area code.
• Press
p
/
q
to move the cursor to
the left or right.
• Press MUTE/DELETE to erase a
digit.
• Press and hold MUTE/DELETE to
erase all digits.
5. Press MENU/SELECT to confirm.
NOTE
• If in the future, your telephone service
provider requires you to dial ten
digits to make a local call (area code
+ telephone number), you need to
delete your home area code. While
the home area code is displaying in
Step 4, press and hold
MUTE/DELETE .
The home area code is now restored
to its default setting of _ _ _(empty).
Press
MENU/SELECT to save.