3
Getting started
Place the battery with the label
THIS SIDE UP
facing up and
the wires inside the battery
compartment.
2.
Plug the battery connector securely
into the socket, matching the
orientation of the engraved label.
1.
Slide the battery compartment cover
towards the center of the handset
until it clicks into place.
3.
Place the handset in the telephone
base or charger to charge.
4.
Battery installation
Install the battery as shown below.
CHARGE
light
remains on
when charging.
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to
digital service from a cable company or a VoIP service provider, the telephone line
may need to be rewired to allow all existing telephone jacks to work. Contact your
cable/VoIP service provider for more information.
•
•
If you want to use the handset(s) of this telephone base with your existing compatible
base, you need to deregister all handsets from this base first, and then register the
handset(s) to the desired compatible base. See page 42 and page 41 for handset
deregistration and handset registration respectively.
If the handset will not be used for a long period of time, disconnect and remove the
battery to prevent any possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com or
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.
•
•
•