32
If this product is equipped with a corded
or cordless handset, it is hearing aid
compatible.
If this product has memory dialing
locations, you may choose to store
emergency telephone numbers (e.g.,
police, fire, medical) in these locations. If
you do store or test emergency numbers,
please:
Remain on the line and briefly explain the
reason for the call before hanging up.
Perform such activities in off-peak hours,
such as early morning or late evening.
Industry Canada
This device complies with Industry Canada
licence-exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation.
Privacy of communications may not be
ensured when using this telephone.
The term ‘’IC:‘’ before the certification/
registration number only signifies that the
Industry Canada technical specifications
were met.
The Ringer Equivalence Number (REN) for
this terminal equipment is 1.0. The REN
is an indication of the maximum number
of devices allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination
of devices subject only to the requirement
that the sum of the RENs of all the devices
does not exceed five.
This product meets the applicable Industry
Canada technical specifications.
California Energy Commission
battery charging testing
instructions
This telephone is set up to comply with the
energy-conserving standards right out of
the box. These instructions are intended for
California Energy Commission (CEC) compliance
testing only. When the CEC battery charging
testing mode is activated, all telephone
functions, except battery charging, will be
disabled.
To activate the CEC battery charging testing
mode:
1. Unplug the telephone base power
adapter from the power outlet. Make sure
all handsets are plugged with charged
batteries before proceeding.
2. While you press and hold
FIND HS
, plug
the telephone base power adapter back to
the power outlet.
3. After about 30 seconds, when the
IN USE
light starts flashing, release
FIND HS
and
then press it again within 2 seconds.
NOTES
NOTE
NOTES
• When the phone successfully enters the CEC
battery charging testing mode, all handsets
display
To register HS
and
See manual
alternatively.
• When the phone fails to enter this mode, repeat
Step 1 through Step 3 above.
To deactivate the CEC battery charging testing
mode:
1. Unplug the telephone base power adapter
from the power outlet, then plug it back in.
Then the telephone base is powered up as
normal.
2. Register your handsets back to the
telephone base. Refer to
Register a
handset
.