3
Align the wall mount bracket and screws with the holes in the
wall as shown. Tighten the screw in the middle hole first, so
that the wall mount bracket position is fixed. You can tighten
the other screw in the top hole.
Place the baby unit on the wall mount bracket. Tighten the
screw into the threaded socket at the bottom to secure the
baby unit.
4
The default angle of the wall mount bracket is 90 degrees.
You can maximize your baby unit’s viewing angles by tilting
the wall mount bracket.
Hold the baby unit, and then rotate the knob in anticlockwise
direction. This will loosen the joint of the wall mount bracket.
Tilt your baby unit up or down to adjust to your preferred
angle. Then, rotate the knob in clockwise direction to tighten
the joint and secure the angle.
5
1
Note:
Check for reception strength and camera
angle before drilling the holes.
Place the wall mount bracket on a wall and then use a pencil to
mark the top and the bottom holes as shown. Remove the wall
mount bracket and drill two holes in the wall (7/32 inch drill bit).
2
I
f you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert
the wall anchors into the holes. Tap gently on the ends with a
hammer until the wall anchors are flush with the wall.
Mount the Baby Unit
BM4010 Baby Unit
Installation Guide
(for use with BM4000 parent unit)
2
Power outlet not controlled
by a wall switch
Bundle the
power cord
