VTech Baby 551803, Инструкция по эксплуатации

Страница: 5 / 11

4
4
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned
OFF
.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw and then open the
battery cover.
3. If used batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AAA batteries following
the diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended are
to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.