VPG TruckWeigh, Руководство по установке, настройке и калибровке

Страница: 32 / 130

32
How to install an air pressure transducer
A single air pressure transducer is used to monitor a single air circuit
in an air suspension system.
For example; a single air circuit with one ride height control valve to
control multiple bellows on both sides of the vehicle. In this case, a
single air pressure transducer is required.
If separate air circuits are present, a transducer must be installed on
each air circuit.
For example; two air circuits, One with a ride height control valve
to control the bellows on the left side and one with a ride height
control valve to control the bellows on the right. In this
case two air pressure transducers are required, one for the
circuit on the left side of the truck and one on the right.
Ensure that you select the appropriate position for
the sensor. Please see “Sensor installation positions”
on page 26 for guidance on selecting a position for
a sensor
1. Build the air pressure transducer:
i. Disconnect the fitting from the internal
domain cable
ii. Place the washer over the thread. It is recommended that PTFE
tape is also applied
iii. Connect the sensor to the fitting. Use
18 mm and 24 mm spanners to tighten
iv. Remove the cap from the sensor
v. Connect the fitting and sensor to the stem of the air pressure
T-connector. Push-fit until you hear two clicks to lock the
sensor and T-connector together
vi. Connect the air pipe fittings to each
side of the tee on the T-connector.
Push-fit until you hear two clicks
to lock the air pipe fitting and
T-connector together
Truck Air
System
Truck Air
System
Truck Air
System
TruckWeigh
®