VPG TruckWeigh, Руководство по установке, настройке и калибровке

Страница: 28 / 130

28
Axle transducer on a leaf spring
Select a position to install the transducer on a single axle leaf spring where:
• The transducer is mounted to the top side of the
spring
• The transducer is parallel to the orientation of the
chassis
• The transducer is as far as possible from the axle.
It can be mounted to the front or rear of the
spring with the internal domain cable running
away from the axle
• The transducer is not at risk of damage from any
part on the vehicle throughout the full range of
movement of the spring
• The internal domain cable can be routed and connected without risk of damage from any moving
parts and allowing for the full range of movement of the transducer on the spring
When mounting the sensor, ensure it is in the correct orientation, with the groove at the top. See
“How to install a steel axle transducer” on page 35 for further guidance
TruckWeigh
®