© 2019 VOXPRIME All rights reserved
Rev:3
VOX-100 SIP / VOX-200 SIP Installation Guide
Download our complete product manual PDF document at: www.voxprime.com/manuals
If you require technical assistance during installation, please call us : 1-888-633-2666
IMPORTANT NOTICE
Page Port
(600 Ohms)
Aux Music
Source
C.O. Port or
Tel. Extension
Dry Contact
Dry Contact
MUSIC IN
1
2
3
4
5
6
7
8
9 10 11 12 13
MUSIC
MUTE
GND
OUTPUT
OUT
COM
MUSIC
IN GND
CONTACT
RING
T
R
MUSIC IN
MODEL VOX-100 SIP
100 WATT AMPLIFIER
TEL RING
TEL
T
R
1
2
3
4
5
6
7
8
Power
Peak Level
Fault
MUSIC
VOL
BASS TREBLE
TEL
VOL
BASS TREBLE
VOX
NIGHT
RINGER
Connections
When these two terminals are shorted together, the
music output of the amplifier will be muted to allow a
telephone page to be heard.
Terminals 1&2 – MUSIC MUTE
Connect to the telephone system page port.
This voice input can only be activated by the
telephone system page port dry contact or the
VOX circuit.
Terminals 3&4 – TEL INPUT (Balanced)
Terminals 5&6 or RCA Jacks – MUSIC IN
Connect a music source to these terminals noting
that pin 6 is a signal ground pin. It is important that
shielded cable be used to avoid any induced hum.
Use some RCA cables to connect the music source
using the RCA jacks.
Volume Controls
DIP Switches
LED Indicators
Music Volume
Music Bass
1
2
3
Music Treble
Tel Volume
Tel Bass
4
5
6
Tel Treble
VOX
Night Ringer
7
8
Power LED
Peak Level LED
Fault LED
ON position Changes the output voltage from 70V to 25V.
1: TEL Off-Hook
2: Ring Cadence
3: 70V – 25V
ON position applies a telephone off-hook condition on the TEL INPUT. Some PBX page ports (e.g., Avaya) requires this condition.
ON position provides the night ringer audio ring cadence of 2 sec. ON / 4 sec. OFF, when a dry contact is applied to Contact Ring.
The Power LED is ON when the equipment is connected to the AC electric outlet and is operational.
The Peak Level LED is ON when the output volume level has reached 70V.
Fault LED is ON when the amplifier is protecting itself from a faulty condition like a short circuit on the 70V output, overheat or an
overload.
Theses controls adjust
the volume, bass and
treble of the music
input source.
Theses controls adjust
the volume, bass and
treble of the Telephone
page port.
VOX Detection Sensitivity Control
Ringing Volume
Terminals 7&8 – CONTACT RING
Terminals 9&10 – TELEPHONE RING
Connect the night ringer relay of the PBX to these
terminals (dry contact activation).
Connect to a C.O. Port, analog telephone extension or to an ATA Module to activate the night ringer with a 90 Volts ringing signal.
Terminals 11&12 – 70V OUTPUT
Connect the speaker wiring to these terminals. Follow the guidelines for Class 3 Wiring.