Vox Lil Looper, Руководство пользователя

Страница: 15 / 100

15
Creating phrases
Turning the power on
1.
Make sure that the volume of your amp or
mixer is sufficiently lowered, and then turn the
Lil' Looper’s POWER switch to the ON position.
The AUTO REC, METRONOME, TAP and CLEAR
buttons light up green when the power is turned on.
2.
Turn on the power of the connected amp or
mixer, and raise the volume.
3.
Play your guitar, and adjust its volume without
allowing the PEAK LED to light-up.
Note:
The Lil' Looper contains an auto power-off
function. The power will automatically turn off
approximately four hours after the last user input
occurred (
)
p. 30 “Auto Power-Off function”).
Turning the power off
1.
Lower the volume of your amp or mixer.
2.
Set the POWER switch to the STANDBY position.
Creating phrases
Let’s record phrases to Loop 1 and Loop 2.
The phrase recorded on a loop will be deleted if
the power is turned off.
Recording on Loop 1
1.
Connect your guitar or mic and amp to the
Lil' Looper, and turn on the power.
)
p. 14 “Connect your instrument and turn on the
power”
Checking the status of each loop
The PLAY status LEDs and REC status LEDs for
Loop 1 and Loop 2 indicate whether each loop
contains a phrase.
Note: If you haven’t recorded anything into the
loops, there’s no need to check.
If the PLAY status LED is unlit, that loop does not
contain a phrase.
If the PLAY status LED is blinking green slowly,
a phrase has been recorded in that loop, and the
phrase is stopped.