VOTI XR3D-6, Техническое обслуживание и устранение неисправностей

Страница: 73 / 94

XR3D-6 Maintenance & Troubleshooting
EM-XR3D-6-001-EN.D 6-1
©2011 VOTI Inc.
6 R
EMOVE AND
R
EPLACE
P
ROCEDURES
An authorized technician performs an X-ray radiation test after each maintenance task
where the XR3D-6 has been opened.
The front of the XR3D-6 is denoted by the location
of the Operator Key Switch (E).
A. Front
B. Back
C. Left - Conveyor Motor (Tunnel Entrance)
D. Right - Conveyor Idler (Tunnel Exit)
E. Operator Key Switch, Keypad, & USB slot
Before any maintenance is performed,
always make sure that the power is turned OFF, preferably at the wall receptacle and at the
UPS.
Attach a Do Not Operate tag to the AC plug or the Operator Key Switch. Do not touch the
terminals or other current-carrying ports while power is being supplied. Electric shock may
occur.
6.1 Access Items in the Base
To access the XR3D-6 source, UPS, Power Distribution Unit, and Conveyor Motor Controller,
remove the front or rear access panels.
To remove the access panels, front or rear, proceed as follows:
1. Unscrew the M6 x 25 SS machine screws with a 6 point security head. Depending on the
model, there are either four (4) or (2 at the top and two at the bottom) or just two (2) at the
bottom.