VOSS.farming 42082, Инструкция по эксплуатации

Страница: 30 / 144

30
42082 - 01.2022 - V5
INSTRUCTION MANUAL VOSS.FARMING SUNNY 200
7.1 INSERT AND CONNECT BATTERY
1. Place the device on a flat surface with the solar module (9) facing down and use a screwdriver
to remove the screw on the battery compartment lock (12).
NOTICE
Make sure that there are no objects on the lying surface so as not to damage the
solar module.
2. Turn the device over, open the battery compartment (11) and insert the battery.
3. Connect the red cable (+) to the positive terminal of the battery.
4. Connect the black cable (-) to the negative terminal of the battery.
5. Close the battery compartment (11) again and screw the previously removed screw back into
the battery compartment lock (12).
7.2 ASSEMBLY
WARNING AGAINST ELECTRICAL VOLTAGES
Do not lay PVC cables at a temperature below +5°C.
NOTICE
Make sure that the device is securely placed during assembly. The device must
later be operated upright with the device lid closed.
Select a mounting location, taking into account the general safety instructions, that meets the
following criteria:
• next to the electric fence and preferably near the center of the electric fence
• where the most amount of sunlight is reached in the season
• where a good grounding can be achieved
• on solid ground away from possible flooding and out of reach of animals and children
(inside the protective fence if necessary)
Info
Direct the device so that the module surface faces south in the northern hemisphere or
north in the southern hemisphere.
Fig .2
Fig .1
Mounting on Y- or T-posts
The electric fence unit can be attached directly to a metal Y- or
T-post via the mount (6).
To do this, push the upper end of the post into the mount (6) on
the underside of the electric fence unit (Fig. 2).
Mounting on wooden post or wall
For mounting on a wooden post or wall, you will need suitable nails
or screws and washers.
1. Fasten the nails or screws at a distance of 205 mm (Fig. 1).
2. Insert the nails or screws so that they protrude by 10 mm (Fig. 1).
3. Place the energiser with the hangers (5 & 8) on the nails or screws
so that the washers are inside the hanger.