DP/N: 007127v1.1, 2012-02-21
© 2012 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured.
6
A.
Locate the supplied body plug and install it into in
the existing hole in the firewall. (See Fig 3-a)
B.
Loosely route the supplied 10 GA wire around the
front of the vehicle to the Power Distribution box.
Attach the supplied fuse holder assembly to the
end of the 10 GA wire.
C.
Using the supplied tee and length of rubber vacu-
um hose, splice the tee into the supercharger
bypass valve signal hose (will see boost and vac-
uum).
D.
Route the supplied 10 GA wire and 1/8" nylon tub-
ing through the previously installed body plug.
Using a sharp blade, slice a small "x" in the center
of the plug to allow the wire to pass through.
E.
From the inside of the vehicle, route the supplied
wire and 1/8" vacuum tubing along the floor
board. Use the supplied wire loom to cover the
wire and vacuum tubing as they are routed to the
rear of the car. Secure the wire to the existing
wires. (See Fig 3-b)
F.
Lift up on the plastic carpet cover and route the
wire toward the rear of the vehicle. (See Fig 3-c)
3.
FUEL PUMP VOLTAGE BOOSTER WIRING
Fig. 3-a
Fig. 3-b
Fig. 3-c
SUPPLIED
BODY PLUG
Route Supplied wire
and vaccum hose