VORON 1.8, Инструкция по сборке

Страница: 6 / 161

6
WWW.VORONDESIGN.COM
BUTTON HEAD CAP SCREW (BHCS)
Metric fastener with a domed shape
head and hex drive. Most commonly
found in locations where M5 fasteners
are used.
ISO 7380-1
SOCKET HEAD CAP SCREW (SHCS)
Metric fastener with a cylindrical head
and hex drive. The most common
fastener used on the Voron.
ISO 4762
HEX NUT
Hex nuts couple with bolts to create a
tight, secure joint. You’ll see these used in
both M3 and M5 variants throughout this
guide.
ISO 4032
SHIM
Not to be confused with stamped
washers. These are used in all M5 call-out
locations in this manual.
DIN 988
IDLER
GT2 idler used in the motion system of
the Voron.
PULLEY
GT2 pulley used on the motion system
of the Voron.
HARDWARE
POST INSTALL T-SLOT NUT
Nut that can be inserted into the slot of
an aluminium profile. Used in
both M3 and M5 variants throughout this
guide.
HAMMER HEAD NUT
Nut that can be inserted into the slot of
an aluminium profile. Used
exclusively for panel mounting, all other
components use T-Slot nuts.