Voom Technologies, Inc. © 2004-2018 Proprietary
7 Serial Interface
With the Shadow 3 unit turned off, connect the supplied serial cable between the
Shadow 3 and a second computer, do not use the suspect computer. Using a
terminal program capable of serial communications, such as HyperTerminal or
Tera Term , configure the serial port (usually COM1) as described in the table
below:
Parameter
Value
Baud Rate
115200
Data Bits
8
Parity
none
Stop Bits
1
Flow Control
none
Serial Port Settings
Once the serial cable is connected and the terminal program configured, the
Shadow 3 unit may be turned on.
On power-up you should see the following sequence:
Start
!-FPGA loaded
Shadow3 1-04 Initializing...
Checking Shadow...
Checking Source...
. (only with a Source change)
!-Source Drive Changed (only with a Source change)
Shadow3 1-04 Ready
Hard Reset
=>
Typing
help
will display a brief description of the available commands.
15
