VONROC AMIATA PH510AC, Оригинальное руководство пользователя

Страница: 6 / 60

EN
6
WWW.VONROC.COM
• If the supply cord of this power tool is dam-
aged, it must be replaced by a specially pre-
pared supply cord available through the service
organization.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm². If you use an extension
cable reel, always fully unroll the cable.
2. MACHINE INFORMATION
Intended use
This product is designed as a patio heater for
domestic environments. The heater is intended for
private gardens or other outdoor areas at home.
The heater may not be used to heat an indoor
space, usage as a non-household outdoor space
heater or for the drying of textiles or other mate-
rials. This heater is not equipped with a device to
control the room temperature so do not use this
heater in spaces when they are occupied by per-
sons not capable of leaving the room on their own,
unless constant supervision is provided. The device
is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse.
TECHNICAL SPECIFICATIONS
Model No. PH510AC
Voltage 220–240 V ~
Frequency 50-60 Hz
Power 2200W
Power settings
1: 730W
2: 1460W
3: 2200W
Heating element type Quartz
Heating time 20 seconds
Wave length 1.4-3.0
Radiant efficiency 60%
Heating distance 3-4m
Heating area 15m²
Electronic soft start Yes
Ingress protection class IP34
Protection class Class I
Weight 1.50 kg
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Heater
2. Protective grill
3. Power level indicator
4. Power cable
5. Pull cord (on/off switch)
6. Mounting bracket
3. ASSEMBLY
This heater should be installed by a
competent person, i.e. a qualified electrician.
Always disconnected the heater from the
electrical supply and allow it to cool before
installation.
Installing the heater (Fig. A­N)
Always mount the device with the supplied
accessories.
Before starting the installation, take the following
into consideration:
• Place the device on a firm, level surface.
• The device must be mounted so that there is
50 cm of free space between the heater and
any ceiling, tent canvas etc. There must also be
at least 200 cm between the ground and the
underside of the device. Refer to Fig. D
The device may never be hung at an angle!
• Ensure that the power supply cable is well
mounted and that it does not come into contact
with reflector of the heater or that does not trail
into heated area.
• Do not install the heater on an inflammable
surface.
• If the heater is to be used outside, a weather-
proof outlet is highly recommended.
• Before drilling ensure that there are no wires or
water pipes in the area where the heater is to
be installed.
To install the heater on a wall, follow these steps:
1. Mark the drill holes on the wall according to the
pattern shown on figure C.
2. Drill the holes into the wall at the marked posi-
tions.
3. Insert the supplied wall plugs into the drill