© VONN Lighting,2017
ON
VONN Lighting
Model: VMC31620
Tools You May Need
GOGGLES
TAPE MEASURE
RUBBER
GLOVES
PHILLIPS
LADDER
DRILL
SCREW DRIVER
Parts List
A.
B.
C.
D.
E.
F.
G.
A
F
G
B
C
D
E
Circuit Box
Mounting Bracket
Anchor Screws x 3
Outlet Screws x 3
Wire Connectors x 3
Ground Screw x 1
Canopy Screws x 2
Plastic Anchors x 3
Installation Guide
Make sure that you have all necessary parts by checking the parts list. If
any part is missing or damaged, please contact
VONN Lighting
Customer Service at 888-604-8666
for a replacement.
Please read and comprehend the entire manual before attempting to
assemble, operate, or install the product.
VONN highly recommends to use a qualified, licensed electrician to install
the fixture.
VONN recommends to install the fixture on its own independent circuit.
Do not install the fixture on the same circuit with other appliances, or
HVAC systems.
DO NOT CUT WIRES
attached to the fixture under any circumstance.
Cutting wires will
VOID
your warranty. Excess cable should be neatly
looped and tucked into the canopy.
LED INFO & WARNINGS
•
•
All parts must be used as indicated in these instructions. Do not substitute
any parts, leave parts out, or use any parts that are worn or broken.
•
Inspect the LED fixture prior to installation to make sure that it has not
been damaged during shipping.
•
Please handle the LED light with care when unpacking. Do not apply
pressure to the LEDʼs, do not open any factory sealed compartments, and
do not touch the LEDs with your hands.
•
•
Place the wall switch in the “OFF” position of the room you are installing
the fixture.
•
Shut “OFF” the electricity at main fuse box.
•
Please remove the canopy from the box prior to the fixture body. Failure
to do so can potentially lead to cables getting tangled.
•
VONN recommends
ELV (Electric Low Voltage)
type dimmers for this
fixture.
•
•
Do not remove or replace VONN manufactured driver that is provided
with the fixture.
