Volvo XC60 Twin Engine 2020, Руководство пользователя

Страница: 446 / 714

STARTING AND DRIVING
* Option/accessory. 444
Starting the car
The car is started using the start knob in the
tunnel console when the remote control key
is in the passenger compartment.
Start knob in the tunnel console.
WARNING
Before starting:
•
Fasten the seatbelt.
•
Adjust the seat, steering wheel and
mirrors.
•
Make sure that the brake pedal can be
fully depressed.
The remote control key is not physically used
when starting the car since it is equipped with
support for keyless starting (Passive start).
To start the car:
IMPORTANT
The car cannot be started if the charging
cable is still engaged. Make sure the
charging cable is removed from the charg-
ing input socket before the starting the car.
1. The remote control key must be inside the
car. For cars with Passive Start, the key
needs to be located in the front part of the
passenger compartment. With the option
for keyless locking/unlocking
*
of the car,
the key can be anywhere in the car.
2. Hold the brake pedal depressed
1
fully. For
cars with automatic gear changing, make
sure that gear position
P or N is selected.
For cars with a manual gearbox, make
sure that the gear lever is in neutral posi-
tion or that the clutch pedal is depressed.
3. Turn the start knob clockwise and then
release it. The control automatically
returns to its starting position.
When the engine is started, the starter motor
works until the engine is started or until its
overheating protection triggers.
When starting in normal conditions, the car's
electric drive motor is prioritised - the petrol
engine remains switched off. This means that
after the start knob has been turned clock-
wise, the electric motor has ”started” and the
car is ready to drive. A started car is indicated
by the driver display's indicator lamps extin-
guishing and its preset theme illuminating.
However, there are situations where the petrol
engine is started instead, e.g. in the event of
the temperature being too low or if the hybrid
battery needs charging.
Error messages
If the Car key not found message is shown in
the driver display when starting, place the
remote control key by the backup reader. Then
try to start the car again.
Backup reader's location in the tunnel console.
1 If the car is moving, the engine can be started by turning the start knob clockwise.