Volvo XC 60 TWIN ENGINE, Руководство пользователя

Страница: 216 / 620

LOADING AND STORAGE
* Option/accessory. 214
Electrical sockets
In the tunnel console there are two 12 V electri-
cal sockets and one 230 V electrical socket
*
, in
the cargo area there is one 12 V electrical
socket
*
.
For the sockets to supply current, the car's elec-
trical system must be set in the lowest ignition
position
I . The sockets are then active as long as
the starter battery level does not become too low.
If the engine is switched off and the car is locked,
the sockets are deactivated. If the engine is
switched off and the car is not locked, or is
locked with blocked lock position temporarily
deactivated, then the sockets continue to be
active for a further ten minutes.
NOTE
Remember that use of the electrical socket
with the engine switched off entails a risk of
discharging the starter battery, which can limit
functionality.
Accessories that are connected to the electri-
cal sockets may be activated even when the
car's electrical system is disconnected or if
preconditioning is used. For this reason, dis-
connect the connectors when they are not in
use in order to avoid the starter battery being
discharged.
Electrical socket in the tunnel console -
rear seat
*
Electrical socket in the tunnel console, rear seat.
The socket can be used for various accessories
requiring a 230 V supply, e.g. chargers and lap-
top computers.
Using the socket
1. Pull down the socket cover and insert the
accessory's plug.
> The LED
1
lamp on the socket indicates
the status.
2. Check that the lamp is illuminated with a
steady green light - only then is current avail-
able at the socket.
3. Disconnect the accessory by pulling out the
plug - do not pull on the cable.
Pull up the cover when the socket is not
being used or the socket is left unattended.
IMPORTANT
Maximum socket output is 150 W.
IMPORTANT
•
Do not use accessories with large or
heavy connectors - they can damage the
socket or come loose when driving.
•
Do not use accessories that can cause
interference to the car's radio receiver or
electrical system for example.
•
Position the accessory so that it is not at
risk of injuring the driver or passengers in
the event of heavy braking or collision.
•
Keep an eye on connected accessories
as they can generate heat that can burn
passengers or the interior.
WARNING
•
Only use accessories that are undam-
aged and fault-free. The accessories
must be rated for 230 V and 50 Hz with
connectors designed for the socket. The
1 LED (Light Emitting Diode)