Volvo V 90 Cross Country, Руководство пользователя

Страница: 154 / 594

INSTRUMENTS AND CONTROLS
152
Operating power windows
Using the driver's door control panel, all power
windows can be operated - using the control
panels in the other doors operates the power
window in the individual door.
WARNING
Check that no children or other passengers
are trapped when the windows are closed
from the driver's door.
WARNING
Check that no children or other passengers
are trapped if/when the windows are closed
using the remote control key.
WARNING
If there are children in the car - remember to
always switch off the power supply to the
power windows by setting the car's electrical
system in ignition position 0 and then take
the remote control key with you when leaving
the car.
Operating
Operating the power windows.
Operating without auto
Operating with auto
Using the driver's door control panel, all power
windows can be operated - using the control
panels in the other doors can only operate the
power window in the individual door. Only one
control panel can be operated at a time.
In order for the power windows to be used, the
ignition position must be at least
I . The power
windows can be operated for a few minutes after
the car has been switched off and after the igni-
tion has been switched off - although not after a
door has been opened.
Closing of the windows is stopped and the win-
dow is opened if anything prevents its movement.
It is possible to override the pinch protection
when closing has been interrupted, e.g. if ice has
formed on the window. After two successive clos-
ing interruptions the pinch protection will be over-
ridden and the automatic function deactivated for
a short while, now it is possible to close by hold-
ing the button in its raised position.
NOTE
One way to reduce the pulsating wind noise
when the rear windows are open is to also
open the front windows slightly.
NOTE
The windows cannot be opened at speeds
above approx. 180 km/h (112 mph), but they
can be closed.
Operating without auto
Move one of the controls up/down gently. The
power windows move up/down as long as the
control is held in position.
Operating with auto
Move one of the controls up/down to the end
position and release it. The window runs auto-
matically to its end position.