Volvo S 60, Руководство пользователя

Страница: 93 / 452

INSTRUMENTS AND CONTROLS
}}
* Option/accessory, for more information, see Introduction. 91
Active main beam
*
Active main beam function detects the headlamp
beams from oncoming traffic or the rear lights of
vehicles in front, and switches the lighting from
main beam to dipped beam. The lighting returns
to main beam when the incoming light has stop-
ped.
Active main beam - AHB
Active main beam (Active High Beam - AHB) is a
function which uses a camera sensor at the top
edge of the windscreen to detect the headlamp
beams from oncoming traffic or the rear lights of
vehicles in front, and then switches from main
beam to dipped beam. The function can also take
streetlights into account.
Main beam is reactivated when the camera sen-
sor no longer sees any oncoming vehicles or
vehicles ahead.
Car with halogen headlamps
The lighting returns to main beam about a sec-
ond after the camera sensor no longer detects
the headlamp beams from oncoming traffic or the
rear lights from vehicles in front.
Car with active Xenon headlamps
If the active main beam has the on/off functional-
ity
21
then the lighting returns to main beam about
a second after the camera sensor no longer
detects the headlamp beams from oncoming
traffic or the rear lights from vehicles in front.
If the active main beam has adaptive functional-
ity
21
then, unlike what happens during conven-
tional dimming, the light beam continues to illu-
minate with main beam on both sides of oncom-
ing traffic or vehicles ahead - only the part of the
light beam that points directly to the vehicle is
dimmed.
Adaptive functionality: Dipped beam directly toward
oncoming vehicles, but continued main beam on both
sides of the vehicle.
The lighting returns to full main beam about a
second after the camera sensor no longer
detects the headlamp beams from oncoming
traffic or the rear lights from vehicles in front.
Activating/deactivating
AHB can be activated when the headlamp con-
trol's knob is in position
(provided that the
function has not been deactivated in the menu
system MY CAR, see MY CAR (p. 111)).
Stalk switch and knob for headlamp control in AUTO
position.
The function can start while driving in the dark
when the car's speed is approx. 20 km/h
(12 mph) or higher.
Activate/deactivate AHB by moving the left-hand
stalk switch towards the steering wheel to the
end position and then releasing. Deactivation
when main beam is on means that the lights are
reset directly to dipped beam.
Car with analogue combined instrument
panel
21 Depending on the car's equipment level.