Volvo S 60, Руководство пользователя

Страница: 331 / 452

WHEELS AND TYRES
}}
* Option/accessory, for more information, see Introduction. 329
Changing wheels - removing wheels
The car's wheels can be changed for e.g. winter
wheels/winter tyres.
Spare wheel *
Two different versions of the spare wheel can be
supplied, in a bag or beneath the cargo floor.
The following instructions only apply if a
spare wheel has been purchased as an
accessory for the car.
If the car is not equipped
with a spare wheel - see information about Emer-
gency puncture repair (TMK) (p. 348).
The spare wheel (Temporary spare) is only
intended for use temporarily and must be
replaced by an ordinary wheel as soon as possi-
ble. The car's handling may be altered by the use
of the spare wheel. The spare wheel is smaller
than the normal wheel. The car's ground clear-
ance is affected accordingly. Pay attention to
high kerbs and do not machine wash the car. If
the spare wheel is fitted on the front axle, you
cannot use snow chains at the same time. On all-
wheel drive cars the drive on the rear axle can be
disconnected. The spare wheel must not be
repaired.
The correct tyre pressure for the spare wheel is
stated in the tyre pressure table (p. 433).
IMPORTANT
•
Never drive faster than 80 km/h
(50 mph) with a spare wheel on the car.
•
The car must never be driven fitted with
more than one "Temporary Spare" wheel.
The spare wheel is located in the spare wheel
well with the outside down. The same bolt runs
through to secure the spare wheel and the foam
block. The foam block contains all the tools nee-
ded to change the wheels.
The spare wheel is supplied in a bag and must be
secured on the cargo area floor using straps.
Cars with two load retaining eyelets.
Turn the handle on the spare wheel bag in
towards the rear seat. Attach the sewn-in ten-
sioning strap hooks in the load retaining eyelets.
Attach the long strap into one of the load retain-
ing eyelets, run the strap around the spare wheel
and through the lower handle. Tighten the short
tensioning strap onto the long one. Attach the
second load retaining eyelet and tighten.
Taking out the spare wheel under the
cargo area floor
1. Fold up the cargo area floor.
2. Undo the retaining screw.
3. Lift out the foam block with its tools.
4. Lift out the spare wheel.
Taking out the spare wheel in the bag
1. Loosen the straps, lift out the spare wheel
from the cargo area and remove it from the
spare wheel bag.
2. Fold up the cargo area floor.
3. Lift the tools and jack out from the foam
block.
Removing
Set up warning triangle (p. 333) if a wheel is
replaced in trafficked location. The car and jack
*
must be on a firm horizontal surface.
1. Apply the parking brake, (p. 297) and
engage reverse gear, or position P if the car
has an automatic gearbox.