27A
IMG-279965
27B
IMG-279966
Illustration A
Select a Ø14 mm (9/16") hole saw.
Replace the centre drill in the hole saw with a Ø5 mm (13/64")
drill. The hole in the centre drill's arbor is greater than the
diameter of the drill, however, wind some tape around the drill so
that it sits firmly in the hole. Do not lock the centre drill with the
locking screw. The drill is only used to guide the hole saw as the
hole in the underside of the dashboard must not be greater than
Ø5 mm (13/64") .
Illustration B
Fit a 13 mm (33/64") drill stop.
Drill out for the cradle's three feet.
Note!
Only drill through the uppermost layer of vinyl and the layer of
foam, not through the layer of plastic (1) on the underside of
the dashboard otherwise the hole will be too large for the nuts,
which are tightened from underneath.
Note!
Do not damage the dashboard.
28
IMG-279967
Select a Ø25 mm (1") hole saw.
Change the centre drill in the hole saw back to the original drill
bit.
Drill for the connection of the connector. Drill through all layers of
the dashboard. Use a 25 mm (1")drill stop.
Note!
Do not damage the dashboard.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Navigation system, portable- 30756311 - V1.4
Page 18 / 71
