Volvo Penta TAMD162C, Инструкция

Страница: 32 / 84

Maintenance schedule
The description applies generally for all engines unless otherwise stated. Some of the maintenance points deal with extra equipment or options, for example, for classifiable
engines. The Maintenance schedule also shows which service intervals apply for the TAMD162C, TAMD163A or TAMD163P engines.
If longer oil change intervals are required than those stated below the oil’s condition must be tested
regularly by submitting oil test samples for analysis by the oil manufacturer.
The time intervals are guides which apply to normal operating conditions. For new or reconditioned
engines see under the heading. “Running-in” on page 4.
Every day before starting the engine (or every 8 hours in continuous operation) check the engine oil
level, engine coolant level, the air cleaner (ACL) pressure drop indicator and the reverse gear oil level.
All points must be checked at least once every year with the exception of points 18, 22, 28, 30 and 31
even if the operating times stated are not reached. Points 18, 22, 28, 30 and 31 apply every other year.
NOTE! Always turn the engine off before starting service procedures.
50 hours 500 hours 1000 hours 2000 hours 24 months 50 hours 400 hours 800 hours 1200 hours 24 months
Use a grease gun and lithium grease: Mobilux EP2, Statoil Uniway EP2N,
Texaco Multifak EP2, Q8 Rembrandt EP2.
Engine oil VDS or CD or CE as per API system. Drain or pump out oil while
engine is hot. Use the engine scavenging pump or remove the oil plug.
Hot oil can cause burns.
Remove the oil filter using the special tool. Lubricate gasket and screw on
new filters by hand. Tighten a further 3/4 turn once gasket is in contact with
the mounting.
Top up oil, start, check for leaks. Stop engine and check oil level again.
Take the oil filter off-line using the control lever. Replace the filter as in the
previous operation. Change the other filter in the same way.
Top up oil, start, check for leaks. Stop engine and check oil level again.
1. Engine oil change.
Note. See table “Engine, oil change intervals” for
information on oil change intervals in relation to
oil quality and the sulfur content of the fuel.
2. Replace engine oil and
bypass filter.
3. Engine oil filters, replace-
ment while engine is run-
ning.
4. Lubricate seal at output
shaft on Twin Disc reverse
gear
(if grease nipple is fitted).
No. Action TAMD162C, TAMD163P Instructions
Info.
pages
TAMD163A
44
44
45
–