3.Junior User Guidebook
6
interface.
9.
USB Host port:
It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "host device".
For example: Saving the waveform to
USB flash disk needs to use this port.
10.
Power on/off
Rear Panel
8
7
6
10
9
1
2
5
3
4
Figure 3-2 Rear Panel
1.
Handle
2.
Air vents
3.
AC power input jack
4.
Fuse
5.
Foot stool
: Adjust the tilt angle of the oscilloscope.
6.
LAN port
: the network port which can be used to connect with PC.
7.
USB Device port:
It is used to transfer data when external USB equipment connects to
the oscilloscope regarded as "slave device". For example: to use this port when
connect PC to the oscilloscope by USB.
8.
Lock Hole
: You can lock the oscilloscope to a fixed location using the security lock
(please buy it yourself) to secure the oscilloscope.
9.
Trig Out(P/F)
port: Trigger signal output or Pass/Fail output, also can be used as the
port of CH2 Output of optional dual-channel waveform generator. The output type can
be set on the menu (Utility menu
→
Output
→
Output).
10.
Out 1
port: Output (single-channel) or CH1 Output (dual-channel)
of optional
waveform generator.
