![background image](http://html.mh-extra.com/html/volt/val-2000-4-bbz/val-2000-4-bbz_installation-instructions_1046278003.webp)
INSTALLATION INSTRUCTIONS
w w w . v o l t l i g h t i n g . c o m
[email protected] • 813.978.3700
VOLT
®
All-Star™ Spotlight
VAL-2000-4-BBZ
Install MR16 Lamp
Install Glare Guard and Shield to Fixture
2
3
Insert the lamp with the correct
wattage and type as marked on the
fixture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch lamp with bare
hands. Use soft cloth to handle lamp.
Screw the shield back onto the
fixture. Pass the glare guard over
the shield and secure with the
lock screw. Tighten until snug.
Socket
MR16 Lamp
(sold separately)
Install/Replace Lamp
Remove the glare guard and the shield to expose the lamp and
replace it with the correct wattage and type marked on the fixture
label. Then reinstall the shield and glare guard to the fixture.
IMPORTANT: Halogen lamps must be protected from moisture and
dust at all times. Always reinstall shield when moved.
Wire Connections
6
Strip both leads from the fixture pigtail. Using two wire
connectors (sold separately), connect the leads from the fixture
to the main low voltage supply cable lead.
Pigtail
Main Supply Cable
Wire Connectors
Clear away an area in the
ground at the wireway slot
on top of the stake. Lay
the luminaire pigtail into
the wireway slot and screw
the fixture onto the stake.
Tighten until snug.
Install Fixture to Stake
5
Fixture
Pigtail
Wireway Slot
Install Stake
4
Board
Stake
Stake
Soil
Ground
Determine the desired location for
mounting the fixture. Hammer the stake
into the ground until flange of stake is
flush to grade. To avoid damage to the
stake, place a board on top of the stake
while hammering.
NOTE: If the ground is hard and the
stake is difficult to install, make a
crosscut in the ground using a flat
shovel.
Glare Guard
Lock Screw
Shield
Fixture
- 4 -
- 5 -