46
Infotainment
Structure of the turntable
The two coaxial cables leading from the TWIN LNB end at the turntable.
The coaxial cable LNB(1) is connected to the control electronics. The LNB(1) output of the control electronics
leads to the input of the CAP converter. Both cable ends are marked red.
In addition to the satellite signal, this cable also carries the control signals between the turntable and the CAP
converter.
The coaxial cable LNB(2) is only used to carry the satellite signal. It is not connected to the control electronics.
It leads via a coupling directly from the LNB(2) to the satellite connection on the galley block.
Cable gland
s599_057
Two coaxial cables to the TWIN-LNB
Input LNB(1)
into the control
electronics of
the turntable
Motor with drive
for turntable
Motor for
adjusting the
rocker
Microswitch for
end stop of the
rocker
Drive of the tapered shaft
Taper for
accommodating
the rocker
Output LNB(1)
from control
electronics of
the turntable to
the CAP
converter
(master cable)
Direct
connection from
LNB(2) to the
satellite
connection on
the galley block
Voltage supply
and 12 V retract
signal
Microswitch for
end stop of the
turntable
