14 | Measurement
13 | Commissioning
Commissioning
Hardware
Proceed as follows to install the software:
1.
Start the tester/specified laptop.
2.
Insert the USB stick with the software into a free USB port.
→
If
Autorun
is activated, then the installation program starts automatically.
→
If
Autorun
is not activated, double click on file
Install.CO2ContentCheck.x.x.xxxx.msi
.
3.
If required, enter the user name of the administrator and the password and click
Yes
.
→
The files are imported and installed.
4.
In the next window click
Next
.
5.
Click
Finish
.
6.
Perform a restart of the specified laptop.
The software was successfully installed.
Connect theCO2 coolant tester using the USB cable (Type A – Mini or Type A – "Fischer") to the tester/specified laptop.
To perform a measurement proceed as follows:
Measurement
Installation Of The Software
INFORMATION
First install the software and then connect the CO2 coolant tester to the tester/speci-
fied laptop. Administrator rights are required for the installation.
NOTE
When the CO2 coolant tester is delivered, condensation must be prevented inside the
equipment. Leave the equipment to stand for 3 hours at the operating location for
temperature compensation before switching it on.
INFORMATION
First install the software and then connect the CO2 coolant tester to the tester/speci-
fied laptop. Administrator rights are required for the installation.
Risk of burns from hot engine and coolant
Ensure that the engine is switched off and that the engine and coolant have cooled down.
WARNING
1.
Open the engine hood.
2.
Hang the CO2 coolant tester on a raised point using the suspension bracket. The CO2 coolant tester must be in normal position, i.e.
hanging vertically. Do not place the CO2 coolant tester in the engine compartment or elsewhere.
Risk of burns from hot liquids
Only open the cover of the expansion tank (coolant tank) when the coolant has cooled down.
WARNING
3.
Unscrew the cover of the expansion tank (coolant tank) and install the coolant adapter. Make sure that the coolant adapter is tightly
fitted on the thread.
4.
Start the CO2 coolant tester by double-clicking
CO2 Content Check
.
5.
Click on
CO2 Test
. (With
Display equipment data
the data of the CO2 coolant tester is shown)
.
6.
Follow the instructions on the screen and comply with and confirm all safety instructions.
At the end of the measuring sequence, a result protocol appears with the measured values (CO2 and cooling system pressure) and a graphic
representation of the CO2 and cooling system pressure curve. This results report can be printed out and saved.
NOTE
Always observe the vehicle-specific repair information provided by the manufacturer.
