The procedure for attaching and for removing the jumper cables is described below. Perform each of
the following steps only in the order described, which follow the letters shown in the illustration
⇒
fig. 189
A – B – C – D
.
Attaching jumper cables
1. Switch off the ignition in both vehicles
⇒
Starting and stopping the engine
.
2. Open the battery cover in the engine compartment if the battery has a cover
⇒
Vehicle battery
.
3. Attach one end of the
red
jumper cable to the
positive terminal
(+)
of the dead battery:
(1)
⇒
.
4. Attach the other end of the
red
jumper cable to the
positive terminal
(+)
of the good battery
(booster battery):
(2)
.
5. Attach one end of the
black
jumper cable to the negative jump-start terminal
⇒
Jump-start
terminal
, or if that is not available, to the
negative terminal
(-)
of the battery in the vehicle
providing assistance
(2)
.
6. Attach the other end of the
black
jumper cable
(3)
to the negative jump-start terminal
⇒
Jump-start
terminal
, or if that is not available,
a bare metal part of the vehicle with the dead battery
. This
part should be connected directly to the engine block. You may also attach the cable to the engine
block itself or to the towing eye installed on the front of the vehicle
⇒
Towing
. Attach the clamp to a
point that is as far away as possible from the dead battery
(1)
⇒
.
7. Route the jumper cables so that they cannot get caught in any moving parts in the engine
compartment of either vehicle.
Starting the engine
x
Start the engine of the vehicle with the good battery that is providing help and let it run at idle
speed.
x
Turn on the ignition of the vehicle with the dead battery. If the engine starts, wait 2 to 3 minutes
until it “runs smoothly” before removing the jumper cables as described below
⇒
. If the engine
does not start within about 10 seconds, turn off the ignition and wait at least 1 minute; then try again.
Before removing the jumper cables
x
Switch off the headlights (if they are on).
x
In the vehicle with the dead battery, switch on the heater fan and the rear window defroster. This
helps to minimize voltage spikes when the cables are disconnected.
Removing jumper cables
With the engine running, remove the jumper cables
in reverse order
to the way they were connected.
1. Disconnect the black (-) cable from the vehicle with the
dead
battery.
2. Disconnect the black (-) cable from the other vehicle (vehicle with the
good
battery).
3. Disconnect the red (+) cable from the other vehicle (vehicle with the
good
battery).
4. Disconnect the red (+) cable from the vehicle with the
dead
battery.
5. Close the battery cover.
6. If necessary, unscrew the towing eye on the front of the vehicle
⇒
Installing the front towing eye
.
Содержание 2015 Golf GTI
Страница 69: ......