Vmac VR150, Руководство пользователя

Страница: 31 / 48

VMAC
–
Vehicle Mounted Air Compressors
Toll Free: 1-800-738-8622 Local: 1-250-740-3200
Fax: 1-250-740-3201
29
You must use the supplied compressor oil in this
system. Failure to use this special oil may result in
damage to the compressor and may void your warranty.
9. Turn the compressor clutch clockwise to speed the fill process.
10. Allow 5 minutes for the oil to drain into the tank, then check the
level at the sight glass at the front of the tank. Continue adding
oil until the level is correct.
Do not overfill the system. Overfilling the system with oil
can flood the sight glass window and make the system
appear empty.
11. Install the fill plug in the inlet control valve and tighten it securely.
12. Place the manual transmission in neutral or the automatic
transmission in park and fully apply the park brake.
13. Start the engine and allow it to reach operating temperature.
14.
Press the “ON” button on the control box, allow the system to
pressurize and return to preset base idle speed.
15.
Press the “OFF” button on the control box.
16. Allow the system to settle for 5 minutes, and then check the oil
level through the sight glass. The level must be between the
minimum and maximum level indicators.
17. Check for oil leaks.
Changing Compressor Oil
If the system has just been operated, shut off the engine and wait at
least 30 seconds for the air pressure to vent before working on the
system. Also allow sufficient time for the oil to cool.
1. Clean the area around the oil drain plug on the front of the air/oil
tank to prevent contamination.
2. Remove the drain plug and drain the oil into a container large
enough to hold at least 5 litres (1.32 U.S. gal.) for the VR70 and
9 litres (2.38 U.S. gal.) for the VR150.