Vmac V900093, Руководство по установке

Страница: 26 / 48

VMAC
–
Vehicle Mounted Air Compressors
Toll Free: 1-888-241-2289
Fax: 1-250-740-3201
24
□
Place the bar straps in position on the inside of the frame, one in
front of the transmission cross-member and one behind, with the
cable straps over the top of the frame. Do not pinch the brake
line with the backing strap or cable.
Carefully bend the brake
lines as required to clear the backing straps and cables.
Depending on chassis configuration, the rear clamp
backing strap may have to be positioned either in front
of or behind the electronic brake module on the inside
of the frame. Select the best location once the tank is in
position.
□
Place the tank assembly under the driver side of the vehicle,
then lift the tank assembly and support it in position so the tops
of the two tank strap mounts fit over the top of the frame rail.
Make sure that that the wire harness is outside the mounts and
is not pinched between the mounts and the frame.
□
Wrap the two tank cable straps around the tank strap mounts.
Make sure that they fit in the upper and lower cut-outs of the tank
strap mounts (Figure 4.3).
Cable must fit
in the grooves
Figure 4.3