Programming the controller set SMART Box 2.0 consisting of:
•
IR receiver
RS232
Low Voltage Control - TRIGGER 5-30V
Potential Free Control (Dry Contact Control)
SMART Box 2.0
Device controller
1/4
PROGRAMMING BUTTON
Страница 1: ...gramming the controller set SMART Box 2 0 consisting of IR receiver RS232 Low Voltage Control TRIGGER 5 30V Potential Free Control Dry Contact Control SMART Box 2 0 Device controller 1 4 PROGRAMMING BUTTON ...
Страница 2: ...t logical 1 5V logical 0 5V 9 flashes the device will receive codes from the UART serial port logical 1 5V logical 0 0V CONNECTION DIAGRAM RS232 control UART PIN 5 CONNECT TO GND PIN 2 3 CONNECT TO DATA PROGRAMMING RS232 control UART HEXAGONAL CODE UP U or 0X55 or 55h STOP S or 0X53 or 53h DOWN D or 0X44 or 44h DECIMAL CODE UP 85 STOP 83 DOWN 68 CONNECTION DIAGRAM IR RECEIVER SHIELD OF SHIELDING W...
Страница 3: ...the IR remote control to turn off the directions code STOP After receiving the code the LED diode will blink fast several times and light up again SMART Box is waiting for the code from the IR remote control switching on the 2 direction After receiving the code the LED diode will blink fast several times and turn off This is the end of programming CONNECTION DIAGRAM POTENTIAL FREE CONTROL GND CONN...
Страница 4: ... for the specific lift model After mounting the equipment before first use check if it is mounted as per the instructions and level If the equipment is not level adjust the mounting Do not use equipment that is not properly installed Do not modify or unscrew elements of the equipment as this may cause a risk of permanent damage to the equipment and or the safety of the users WARRANTY CONDITIONS Th...