VXS7910
INSTALLATION GUIDE
PAGE 1 of 2
BEFORE BEGINNING YOUR INSTALLATION
Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.
CONTENTS
5-Sound Control Box (Model: CJB100)
100W Speaker
PA Microphone with Bracket
Double Sided Pads
SAFETY INSTRUCTIONS
Make sure you never attempt to disassemble this horn kit’s electrical components.
Avoid operating this product in an area with risk of falling or submergence into a liquid (water).
Make sure you set up in areas with good ventilation.
Never sound the air horn anywhere near your ear(s) or that of another person.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drilling operations.
Do not replace your vehicle's factory horn with this unit or use it as a warning device.
The specific voltage requirement for this horn kit is 12 volt DC, therefore installation must be done to a DC power
source of 12 volts.
MOUNTING
CONTROL BOX
Find a mounting location in which you will have access to the buttons, knob and connectors of the control
box.
Mount the unit on the location chosen with the provided double sided pads.
SPEAKER
The ideal location for the speaker to be installed is a dry area inside your engine compartment where it will be
safe from exhaust and engine manifold heat.
To make the speaker firm and secure use the mounting bracket as a template to mark the holes location and
drill using a 1/8" drill bit.
Secure speaker with four self-tapping screws (not provided).
IMPORTANT
: The downward orientation of the speaker will prevent water to get inside.
