
Revision History:
Rev. 1.0: Initial release
VIVOTEK Mounting Accessories
AM-412 Corner mount
Installation Guide
Mechanical Drawings
II
Installation
III
Compatible VIVOTEK Cameras
I
AM-412
Corner mount bracket
170
315,25
45
6
215,71
7
86
102
86
102
M8X20mm
SUS 302
Below is a general, sample procedure using a Corner mount bracket:
1. Combine the two metal pieces together using the M8 hex nuts and washers.
2. Align the assembled brackets with the desired position. Align screw holes on the brackets against the wall. Drill
holes on the wall for securing the bracket and for routing the cables. Hammer the anchors into the wall. Note
that these screws and wall anchors are user-supplied.
Corresponding ordering part numbers:
AM-412: 900034900G
AM-714: 100134800G
AM-715: 100134700G
AM-218: 100146100G
Compatible
accessories
Supported Cameras
AM-714
IB836B-HF3/6B-EHF3, IB836B-HT/6B-EHT, IB9371-HT/71-EHT, IB8382-F3/82-EF3,
IB8382-T/82-ET, IB9381-HT/81-EHT, IB9371-HRT, IB9381-HRT
AM-715
IB8367/67-R, IB8367-T/67-RT, IB8338-H/38-HR
AM-218 (via AM-714) Please refer to AM-218 documents.
Directly attached
Supported Cameras
*
IB836B-HF3/6B-EHF3, IB836B-HT/6B-EHT, IB9371-HT/71-EHT, IB8382-F3/82-EF3,
IB8382-T/82-ET, IB9381-HT/81-EHT, IB9371-HRT, IB9381-HRT
* The directly-attached configuration is less recommended for the lack of waterproof and cabling
protection. If directly attached, you should properly wrap the rear-end cables and connectors with
waterproof protection such as putties.
Package Contents
Items
1. Corner mount bracket, 2. M6X20mm screws x4. 3. M5X20mm screws x4, 4. Hex L
wrench 5mm x1, 5. Hex L wrench 4mm x1, 6. M9 nut x2.
M6X20 X4
5mm
X1
M5X20
X4
4mm
X1
M8
X2
Bullet camera
AM-714
- or -
AM-715
AM-412
AM-218
Dome camera
AM-520 / AM-525, etc.
AM-412
AM-714
AM-412
Applications
x8
3. The 4 screw holes in the center are used for directly mounting the IB series bullet cameras.
The 4 screw holes at the edges are used for mounting the AM-714 conduit box.
For M6 socket screws
- for IB series bullet cameras
directly attached
For M5 socket screws
- for AM-714 conduit box
4. Secure the AM-714 conduit box to bracket using the M5 screws, washers, and hex heads. A hex crescent
wrench is required.
The 3/4" cable glands and conduts for protecting cables are user-supplied.
M5
5. For the rest of the installation procedure, refer to the documentation that came with the AM-714, AM-715, AM-
218, and the other accessories.