Vivarium Electronics Series 2 Cage Assembly instructions
1. Congratulations on your new Vivarium
Electronics enclosure. For years of service please
follow the following assembly and use instructions.
First please familiarize yourself with the parts used
to assemble the enclosure and their features.
The cage bottom has a section relieved on the right
underside to aid in under tank heating. Please note
that the recess continues through the cage rear but
is not visible from the front. This will make
orienting this panel easier during assembly
2. The Side Panels are identical with “feet” on the
bottom and stacking recesses on top. The top of
each side panel also has small slots precut front
and rear. These are to allow easy passage of probe
or power cords into the cage.
The Rear Panel has these probe cord/power cord
slots on each end as well as pre-scored potential
openings for larger power cords such as those
used by VE Radiant Heat Panels.
4. During the cage assembly make sure to keep
the panel edges properly aligned and pay
attention that the screws are straight when
screwing the panels together. A little extra time
here will ensure a nice finished assembly.