Vivaldi GIADA 16HPA, Руководство пользователя

Страница: 3 / 4

For immediate diagnosis you can check if there is the presence of audio signal thanks to the LEDs
on the card.
•
Audio Led: If on, it indicates the presence of audio and the status of the amplifier.
•
Status Led: Fast blinking for 10 seconds after power on, indicates the startup status of the
module. Slow flashing indicates turning off, after 5 minutes, of the amplifier.
•
Broken Fuse Led: If on, it indicates that the fuse is blown and must be replaced (2A).
Thanks to a potentiometer located on the rear of the electronics, it is possible to adjust the threshold
audio level detectable by the device.
In the case in which the module does not come into SLEEP MODE, for default after 5 Minutes, it
will be enough to lower the threshold by rotating the potentiometer.
In the opposite case, if the signal is too low and the amplifier will not turn on, simply increase the
threshold until it turn on.
The other potentiometer is used to increase the delay time in SLEEP MODE, from a minimum of 1
minute to a maximum of 20, default is set to 5 minute.
3 TECHNICAL SPECIFICATIONS
Supply Voltage 24Vdc
Maximum Current 2A
Audio Power RMS 50W
Woofer 16,5 cm Kevlar
Tweeter 2,5cm orientable
Dimension (WxHxD) 219x306x90 mm
Recessed hole (WxH) 190x275 mm
Weight 2,2Kg
GIADA 16HPA 2