– 3 –
2. Be sure that the switch is in the OFF-position
before connecting the machine to the
mains voltage.
3. Always keep away the mains lead from moving
parts of the machine.
4. Do not apply side-pressure to the saw blade. It
can break the blade and cause injury.
5. Remove the plug out of the wall socket before
you open the machine.
IMMEDIATELY SWITCH OFF THE
MACHINE IN CASE OF:
• Excessive sparking of the brushes.
• Malfunction of the mains plug, socket or
damaged cables.
• Broken switch.
• Smoke or smell caused by scorched insulation.
ASSEMBLY
Read the manual carefully before installation
1. Clean the working area, open the package and
remove all packing materials, you will find the
folded machine. (see FIGURE 1)
FIGURE 1
2. Lay the machine on its side on the ground,
assemble one leg by screwing it into the nut
welded under the main frame (see FIGURE 2),
make sure it is tightened by means of tools (see
FIGURE 3 and FIGURE4).
Following the same procedure to fix other 3 legs,
and then stand the saw upright.
FIGURE 2
FIGURE 3
FIGURE 4
To stabilize and level the saw, adjust the leveling
“set screw” located on the bottom of one leg
(see FIGURE 5).
FIGURE 5
3. To assemble the handle, position the handle
against the blade guard and secure it using the
attached 3 screws.
4. The cutting unit is locked in the middle of slide
rail during shipment. Before using the saw, pull
the lock knob out of its slot and rotate and put it
into the upright slot (see FIGURE 6).
lock knob
FIGURE 6
05
