VITO VISC21235, Инструкция по эксплуатации

Страница: 32 / 48

Question/problem - cause
Cause
Solution
The power tool does not switch on:
•
The power cord is unplugged or there is an electrical
breakdown;
•
The extension cord is too long or the cross-section of
the wire is too thin;
•
The supply voltage is too low;
•
Motor overheating;
•
Check the plug, socket and circuit breaker;
•
Remove or replace the extension cord;
Plug the power cord directly into the socket;
•
Check that the supply voltage is appropriate;
•
Let the power tool cool for 2 minutes and then switch it
back on;
Excessive vibrations:
•
Loose bolts or parts;
•
The blade is installed incorrectly;
•
The workpiece dimensions are larger than the
appliance cutting capacity;
•
Tighten the bolts and secure the loose parts;
•
Install the blade correctly;
•
Choose workpieces according to the cutting capacity of
the appliance;
The blade vibrates or slips during operation:
•
The blade is not properly secured;
•
Tighten the bolt;
The cutting depth is below the set depth:
•
There is sawdust accumulated under the base plate;
•
Clean the base plate;
Burns on the cut workpiece:
•
The blade is damaged;
•
The circular saw is being pushed too fast;
•
Replace the blade;
•
Reduce the speed when pushing the circular saw;
Poor cutting performance:
•
The blade is damaged or dirty;
•
The blade is not the appropriate for the intended task;
•
The saw blade is installed incorrectly;
•
Clean and replace the blade;
•
Replace the blade by the correct one;
•
Check that the blade is installed correctly;
The blade does not cut straight:
•
The blade is not sharp;
•
The blade is installed incorrectly;
•
The circular saw is not being guided properly;
•
Install a sharp blade on the circular saw;
•
Check that the blade is installed correctly;
•
Use the parallel guide;