Vitek VT-8247, Инструкция по эксплуатации

Страница: 6 / 40

6
ENGLISH
•
Unpack the hot air styler and remove any stickers that can
prevent unit operation.
•
Unwind the power cord completely.
•
Install one of the attachments (8, 9, 10). To do this insert
the attachment into the installation place (1) and turn it
clockwise. If the attachment is set properly, you will hear the
release button (2) click.
•
Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
•
Make sure that the operation mode switch (3) is set to the
position “0”.
•
Insert the power plug into the mains socket.
•
Use the switch (3) to set the required parameters of the air
flow, the indicator (4) will be glowing during the operation:
«0» – the hot air styler is off;
«
» – «cool» air supply;
«1» – low air flow temperature;
«2» – high air flow temperature;
Note: During the first operation some foreign smell and a small
amount of smoke from the heating element are possible, this
is normal.
•
After the hot air styler operation is finished, switch it off by
setting the switch (3) to the «0» position and unplug it.
•
Wait till the hot air styler cools down.
•
To remove the attachment, press and hold the attach-
ment release button (2) and turn the attachment counter-
clockwise.
Overheating protection
Overheating protection switches the hot air styler off if the tem-
perature of the outgoing air is above the limit. If the hot air styler
is switched off during operation, set
the switch (3) to the «0» position, unplug the unit and make
sure that the inlets and outlets are unblocked. Let the unit cool
down for 5-10 minutes and switch it on again. Do not block the
air inlets during the hot air styler operation and avoid getting of
hair into its air inlet.
CLEANING AND CARE
The hot air styler is intended for household use only.
•
Set the switch (3) to the «0» position, disconnect the hot air
styler from the mains and let it cool down.
•
To remove the attachment, press and hold the attachment
release button (2) and turn the attachment counterclockwise.
•
Wipe the unit body (5) with a damp cloth and then wipe it dry.