Vital Elite LTC Bed, Инструкция по эксплуатации

Страница: 21 / 34

Instruction manual VitalFlex Elite LTC Bed
Last update:03.16.2021 Page 20 of 34
7.6 Emergency lowering
7.6.1 Emergency lowering via integrated 9V battery (electric)
The control unit mounted on the lying surface is equipped with two 9V block batteries, which enable the
individual electrical adjustment functions to be lowered in the event of a mains power failure. If the
mains power fails, you have the option of returning the electric drives to their lowest position. Please
note that this is only possible once per battery charge, as the capacity of the 9V batteries is limited.
After using the emergency lowering once, the 9V block batteries must be replaced with new
equivalent ones (alkaline manganese battery type 6LR61).
However, the 9V block batteries should be replaced every 2 years even if they are not used.
7.6.2 Battery change
To replace, check or remove the 9V batteries for longer storage, the batteries must be removed from the
battery compartment on the lying surface drive, which is installed under the lying surface.
Replace the batteries as follows:
• Disconnect the mains plug!
• Slide the batteries out of the battery compartment.
Battery clip
9V-Battery
• Remove the batteries from the battery clip.
• Replace the batteries with new equivalent batteries of the type "Alkali- Manganese battery
type 6LR61".
• Reinsert the battery clips.
• Slide the batteries back into the battery compartment.