Vista SmartDisc 4/10 VLS-04DR-Series, Руководство по установке

Страница: 63 / 74

9 Factory settings
62 Vista SmartDisc
Site Archive
Video settings For all cameras: Recording quality= ; conditional refresh= active
Archive passwords No archive password entered
Track settings Operating mode= (Duplex) live image transmission and recording or archive
evaluation; track partitioning= identical partitioning of maximum storage
capacity for all camera tracks
POS Keyword: all without entry; option All: all active
Video x in For all video inputs:
All set to continuous recording ;
Record preview images = not active; Overwrite protection= not active (preset
warning threshold= 90%); Report period less than= not active (preset = 30
days); Delete all pictures older than= not active (preset= 30 days);
Event triggered
recording
For all video inputs: Event trigger: Trigger via contact= Normally opened;
Trigger via motion detection= off; Trigger via serial command= off; Retrigger
at= not active (preset= 75%);
Event size: Desired number of events= 5,000; Duration Pre-alarm (s)= 5;
Interval Pre-alarm (s) = 1; Duration Alarm (s) = 15 s; Interval Alarm (s) = 0
(quickest possible)
Continuous
recording
For all video inputs: Use easy mode = active; Continuous recording every = 1
second;
Preset for non-easy mode:
Contact status Closed: Rec. method/trigger = Off; Recording interval (s) = 1;
number frames = 1
Contact status Opening (Edge +): Recording method/trigger = Off; Recording
interval (s) = 1; Number of images = 1
Contact status Open: Recording method/trigger = Permanent; Recording
interval (s) = 1; Number of images = 1
Contact status Closing (Edge –): Recording method/trigger = Off; Recording
interval (s) = 1; Number of images = 10
General settings Part 2/2
Audio Listen = off, speak = off
Relay Relay 1: Name= Relay 1; mode = Latch; Closed while idle = not active; Reset
offline = active; Closed= 10 s
Relay 2: Name = Relay 2; mode = Latch;Closed while idle = not active; Reset
offline = active; Closed= 10 s
PTZ control No PTZ protocol assigned; Deactivate PTZ = not active
Serial channel Baud rate= 9,600; Mode= 8N1 (8 data bits, no parity, 1 stop bit); Function =
Serial control
Video monitor Sequencer operation= active; video camera 1= active; all other cameras= not
active; all switch times set to 2 s
Extras
Log file Last caller= not active; Change of inputs = not active; Only when armed = not
active; Temperature = active; Video signal loss detection = not active;
Service Alarm call in case of defective Hard Disk = active; Routine call every 24 hours
= not active;
Extra Operation without hard disk drive = not active; Hang-up and redial on alarm
= not active; Release access for PTZ, Relay, Audio after [] seconds = 60;
Software video signal lost detection = Immediately