D-307122 WCDMA-3G PG2 Installation Instructions
WCDMA-3G PG2
Internal WCDMA-3G module for PowerMaster control panels
Installation Instructions
1. INTRODUCTION
The internal WCDMA-3G module enables the PowerMaster control panel to
operate over a GSM/GPRS/UMTS cellular network. The WCDMA-3G
model is optional and can be installed in any of the following control panels:
•
PowerMaster-10 G2, see figure 1a for details.
•
PowerMaster-30 G2, see figure 1a for details.
•
PowerMaster-33 G2, see figure 1a for details.
•
PowerMaster-360R, see figure 1b for details.
Fig. 1a WCDMA-3G PG2
Fig. 1b WCDMA-3G PG2
2. INSTALLATION
1.
Release screws.
2.
Remove front unit.
3.
Plug in the WCDMA-3G
module and fasten it with the
screw.
4.
For PowerMaster-33 G2,
ensure that the two leading
slots (D) on both sides of the
module slide along the two
leading ribs (C) on the front
unit.
Fig. 2.1 WCDMA-3G PG2 module mounting
PowerMaster-33 G2
Fig. 2.2 WCDMA-3G PG2 module mounting
PowerMaster-10 G2 and PowerMaster-30 G2
A.
WCDMA-3G PG2 module
B.
Front unit
C.
*Leading ribs
D. *
Leading slot (1 of 2)
*
PowerMaster-33 G2 only
1.
Use a coin or 3 mm flathead
screwdriver to rotate the lock
by 90 degrees counter
clockwise to the unlocked
position.
2.
Use minimal force to pull the
panel from the base.
3.
Plug in the WCDMA-3G
module and fasten it with the
screw.
Fig. 2.3 WCDMA-3G PG2 module mounting PowerMaster-360R
A
B
1
