D-304457 PB-101 PG2 / PB-102 PG2 Installation Instructions
1
1. INTRODUCTION
The PB-101 PG2 and PB- 102 PG2 are small PowerG pendants, designed for use with
PowerMaster control panels and other PowerG receivers.
To activate transmission, press the pushbutton (s) at the center of the unit. When
activated, the transmitter sends an alarm code, a LED indication that confirms successful
or failed transmission, and
(only in PB-102)
a buzzer sounds.
The PB-101/102 has several options for carrying or mounting it. The unit is supplied with a
belt clip, a key chain, a lanyard necklace, and a holder which can be attached to the belt
clip or mounted on a wall.
Figure 1. PB-101 and PB-102
2. OPERATION
Caution! This equipment must be used in non-hazardous locations only. This equipment is designed and listed for use in
security / alarm systems and applications. It is not designed or listed for use in health care signaling or life safety applications.
The following functions are available:
Function
PB-101
PB-102
Panic
The signal notifies your
panel of an emergency
situation.
Press and hold the button down for 3 – 5 seconds, the
red LED lights. The green LED lights to confirm a
successful transmission.
Press and hold both buttons
down simultaneously for more
than 3 seconds.
Arm
Arm your system in the
Away mode.
---
Not applicable
Press and hold this button for at
least 1 second.
Disarm
Disarm your system.
---
Not applicable
Press and hold this button for at
least 1 second.
3. ASSEMBLY FOR PORTABILITY AND MOUNTING
This section describes how to attach the PB-101/102 to various portability options.
Warning! Choking Hazard; Small parts; The pendant and belt clip are NOT for children under 3 years.
Figure 2 Attaching PB-101/102 to a Belt Clip
1.
Slide the PB-101/102 into the holder until you feel it snap
securely inside.
2.
To attach the belt clip, slide it onto the rails on the rear of the
holder.
3.
To remove the PB-101/102 from the wall-mounted holder or from the belt
clip, press down the top of the holder and push the pendant up with your
fingers.
Figure 3 Attaching PB-101/102 to a Key Chain
Figure 4 Attaching PB-101/102 to a Lanyard Necklace
PB-101 PG2 / PB-102 PG2
Wireless Panic Button
Installation Instructions