Vislink Strata RX, Техническое справочное руководство

Страница: 50 / 186

Routine Operation 3-22
Strata RX
Operator’s Guide/Tech Ref Manual
3.5.4 Selecting the IF Filter
The Strata RX provides two switchable IF Filters, one optimized
for analog operation and one for digital. These switchable filters
are located with the RF/IF circuitry in the RXU.
Note Be sure to use the correct filter - use the Digital
filter during digital operation and the Analog setting
for analog operation.
If the filter setting is incorrect the system
performance will be degraded.
To select the IF Filter setting, follow these steps:
Be sure Strata is connected and
powered. See “Setting Up” and
“Turning the power ON and OFF”.
Start at the Main Screen.
Turn the Control Switch LEFT until the
display reads
Set IF Filter.
The display will also indicate
Ana
or
Dig
.
Push the Control Switch to change
the Filter setting.
Preset #3
-43.2 dBm
Note If your RX System contains only an RCU, the front
panel menus will still show the
Set IF Filter
choice. However that choice will not operate and
should be ignored.
Display indicates the new setting,
then changes back to the Main
Screen after the default delay.