Template Operators Manual
FocalPoint Camera Control
Issue No: 1
Page: 41
Ref: INHG-ASUM-70XX
Copyright © 2020 IMT and Vislink are Vislink Technologies Inc. companies
NOTE: Refer to the FocalPoint manual for functionality and configuration
details.
8.2.2.2.
Generic/Transparent mode
Generic mode activates control of the Grass Valley camera using the GV
Serial Full protocol. The Serial Full protocol activates full functionality of
the camera but only allows one controller and camera per FocalPoint
system in Transparent mode.
This protocol requires Return Data configured, Scan mode not available
(only 1 x FocalPoint Tx Head).
NOTE: Refer to the FocalPoint manual for functionality and configuration
details.
8.2.3.
Menu descriptions
The following menus are an overview of the available options:
CAMERA CONTROL
>
Control
•
Enables or Disables Camera Control functionality
Can only be Enabled if the Camera Control is Licensed
SETUP
>
Camera ID
•
Sets the address of the data received from Controller. OCP/RCP address.
SETUP
>
OCP Type
•
Sets the Manufacturer Camera/Controller
SETUP
>
Return Data
•
Enables or Disables Return data
Return data is a way of sending camera data back to the controller. The
data is Encoded & Decoded through the Video links ‘User Data’ path.
Return Data is not always required but preferred.
SETUP
>
RETURN DATA SETUP
>
Standard
•
Sets the User Data Standard to ‘Link’ or ‘Gigawave’ to accommodate Video
Receiver
SETUP
>
RETURN DATA SETUP
>
PID
•
Sets Return Data PID number. This must match the User Data PID set in the
Video Receiver