VP-4 Pager – Programming User Guide – Version 1.01
1
VP-4 Pager – Programming User Guide
Note
: The section below applies to pagers labeled with
8108-V4
or later versions. For previous versions, please refer to page 3.
Manual Programming Mode
The manual programming provides access to the settings of 6 capcodes, baud rate, frequency and data polarity.
1.
Insert a battery and turn on the pager.
2.
a. Press the
▲
key until the graphic menu is displayed.
b. Press the
►
key until the display shows
ON/OFF PAGER
.
c. Press the
▲
key to turn off the pager.
3.
Press and hold both the
►
and
▲
keys until the password screen is displayed.
4.
Enter the password. Use the
▲
key to select a digit and press
►
key to navigate to the next password digit. After the 4th digit
was entered, press the
READ/ON-OFF
key.
Note
: Default password is
1141
.
Changing Capcodes
1.
Enter the manual programming mode as described in the Manual Programming Mode section. The display will show
ABFLPq
.
2.
a. Verify that the
A
field is underlined or use the
►
key to navigate the cursor to the
A
field.
b. Press the
READ/ON-OFF
key.
3.
The display will show “
1:
CCCCCCC
0 P
”, where CCCCCCC is the capcode already programmed in to the pager.
The first digit label represents the number of the capcode (capcode ID) to be edited. For example, 1 represents capcode #1 and 6
represents capcode #6.
4.
Select the ID of the capcode to be edited using the
▲
key.
5.
Press the
►
key. The cursor will move to the
CAPCODE
field.
6.
a. Use the
▲
key to enter a respective capcode digit for each underlined digit in the capcode field.
b. Press the
►
key to navigate to the next digit.
c. After the rightmost digit was entered, press the
►
key. The cursor will move to the
ON/OFF
field.
Note
: Standard capcode range is from 0000008 to 2097151. Invalid capcodes will be rejected.
7.
a. Use the
▲
key to toggle between
1
(ON) and
0
(OFF) for the selected capcode. If you wish the capcode to be active, select
1
(ON).
b. Press the
►
key. The cursor will move to the
TYPE
field
8.
Use the
▲
key to toggle between
P
(PERSONAL) and
M
(MAILDROP) for the selected capcode. Recommended value is
P
.
9.
Press the
►
key. The cursor will move to the capcode ID field.
10.
To program additional capcodes, press the
▲
key to select the capcode to be programmed and repeat steps 5-8 for each
capcode. Otherwise, press the
READ/ON-OFF
key to return to the main programming menu.
11.
a. If additional programming is not required, press the
►
key until the cursor is under the
q
field.
b. Press the
READ/ON-OFF
key to exit the programming mode and return to standard operation mode.
