© 2020
Order #XXXXX
Locked layer contains
placeholder marks.
Completed Assembly
Steps:
1) Attach base plate to bottom of post, using bolt.
2) Slide assembled header frame, over connector, on top of post.
3) Attach graphic to clamps. See A10 Clamp detail.
Bolt
Base
Plate
Z-Plate
Graphic
Post
Header
Frame
Connector
Header Frame Assembly
1) Attach frame pieces together, as shown,
with graphic infill between.
2) Attach vertical to bottom of assembled frame.
12.52” extrusion
12.52” extrusion
15” extrusion
10” extrusion
15” extrusion
Graphic Infill
Header frame stays assembled, when packing.
Slide header frame, over
connector, on top of Z-plate.
Connector
Z-Plate
Header Frame
A10 Clamp
Tighten knob to secure
graphic into clamps.
Keep connectors, clamps, and Z-plate attached to post,
when packing.
MOD-9002 Hand Sanitizer Stand with Graphic
If you would like to tell us about your experience with your setup instructions please email us at
SETUP INSTRUCTIONS
