© 2020
Order #XXXXX
Locked layer contains
placeholder marks.
Completed Assembly
Steps:
1) Attach base plate to bottom of post, using bolt.
2) Connect Z-plate to front of post, using bolts. See
V4 Connector
detail.
3) Attach Z-plate to top of post, using bolt.
4) Attach graphic to clamps. See
Graphic Attachment
detail.
Bolt
V4
Base
Plate
Bolt
Bolt
Bolt
Z-Plate
Post
V4
V4 Connector
Slide V4 into groove of post,
then secure with set screw.
Set
Screw
To prevent product loss, keep
all screws attached to V4 after
disassembling.
Keep V4 connectors attached to post when packing.
Post
V4
Knob
Set Screw
Connector
Clamp
1) Slide connector of clamp
into groove of extrusion.
2) Tighten set screw on
clamp, to secure in place.
3) Insert graphic into clamp.
4) Tighten knob on clamp,
to secure graphic in place.
Graphic Attachment
Clamp
Graphic
Clamp
Clamp
MOD-9001 Hand Sanitizer Stand w/ Graphic
If you would like to tell us about your experience with your setup instructions please email us at
SETUP INSTRUCTIONS