Operation
1.
Opening the garage door to change angle of detector will send the status of
"ON"(Basic Set,Value:0xFF) to any associated nodes, and the LED will flash once.
2.
Closing the garage door to change angle of detector will send the status of
"OFF"(Basic Set,Value:0x00) to any associated nodes, and the LED will flash once.
3.
Normal operation, the LED will not light.
4.
The ZG8101 detector equipped with tamper switch. If the cover of detector is
removed, the garage detector will send an alarm report (type:0x07, level:0xFF) to
the Z-
Wave™ Interface Controller, and the LED will go solid. Before replacing the
cover, the detector is under
“Awake” mode.
Federal Communications Commission Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try and correct the interferene by one of the following measures:
Reorient or relocate the receiving antenna,
Increase the separation between the equipment and receiver,
Connect the equipment into and outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undersired
operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user
’s authority to operate this equipment.
Limited Warranty
Vision Guarantees that every wireless garage door detector is free from physical defects
in material and workmanship under normal use for one year from the date of purchase. If
the product proves defective during this one-year warranty period, Vision will replace it
free of charge. Vision does not issue any refunds. This warranty is extended to the
original end user purchase only and is not transferable. This warranty does not apply to :
(1) damage to units caused by accident, dropping or abuse in handling, or any negligent
use; (2) units which have been subject to unauthorized repair, taken apart, or otherwise
modified; (3) units not used in accordance with instruction; (4) damages exceeding the
cost of the product; (5) transit damage, initial installation costs, removal cost, or
reinstallation cost.
For information on addional devices, plesae visit us at
www.visionsecurity.com.tw
ZG 8101 V1 1020717
6B1Z-81001
-3-
Installation & Operation Manual
ZG 8101 IN
ZG 8101 EU
ZG 8101 RU
ZG 8101 US
ZG 8101 JP
ZG 8101 BR
Wireless Garage Door Detector