Visage Lighting & Effects
www.batmink.co.uk
IR Remote Function; when switched on the fitting can be used with the correct IR remote
control (available separately)
Display Normal/Reverse; enables the user to switch over the display in a reverse mode.
Initialisation setting; enables you to combine the first four colours only in the jumping mode
(
AJ01
). To enable press
SET UP
until the display shows
dEFA
and the display flickers, now
press
UP
and
DOWN
buttons at the same time.
Infra Red Remote Control Operation Mode.
This allows the fitting to be operated by a separate remote control (available separately).
Press “
MODE
” button, press “
UP
” and “
Down
” buttons to select “
1ron
” this means the unit
can now be operated using the separate remote control.
Listed below are the various programs and selections available on the remote control.
Auto Run Mode
Press SL/AU button to cycle among auto run mode, colour dream, colour jump, sound
activate and slave mode. Each press of this button will change to the next step. When the
Multipar goes into the Auto run mode, By pressing
FS/SP
button to set the auto run speed
and press “
+
” and “
-
“ to adjust.
Select program Mode
Press “
PROG
” button to select static colour select mode. Then press “
+
” and “
-
“to select
from the 63 static colours and the 14 running modes in this program.
When the Multipar is in the static colour selection you can press
FS/SP
button to turn on
flash and this can be adjusted using the “
+
” and “
-
“ keys.
When the Multipar is in the Running mode programs you can press FS/SP and this will adjust
the speed using “
+
” and “
-
“ keys.
When the Multipar goes into Sound activate mode you can press “
+
” and “
-
“ keys to select
from 16 different sound modes. You can press the
FS/SP
button to adjust the sound
sensitivity.
M/S Mode
Press “SL/AU” button to select between the auto run mode, sound activate and slave mode.
Each press of the button will change to the next mode.
Select light Program mode.
Press R,G,B,W,A,UV to choose any one of the colours, you can then use the “
+
” and “
-
“
buttons to adjust the intensity. Pressing the “A” button to switch between the Amber and
